Specification sheet Backhoe Loader Ref bell-equipment-315sg-loader-backhoe
Bell Equipment 315SG
The Bell Equipment 315SG is a backhoe loader with a 84.5 hp engine, a 1.31 yd³ (1 m³) bucket, and a dig depth of 13.92 ft (4,240 mm).
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Engine power
84.5hp
63kW
Gross Power Bucket capacity
1.31yd³
1m³
Dig depth
13.92ft
4,240mm
◆Where it sits in its classpercentile · backhoe loaders
Among 294 backhoe loaders , the Bell Equipment 315SG sits in the middle of its class:
- Engine power 85 hp less powerful than 53% (n=282)
- Dig depth 13.9 ft shallower-digging than 80% (n=256)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Engine Make | 2240 | |
|---|---|---|
| Engine Model | 4045T | |
| Gross Power | 84.5hp | 63kw |
| Aspiration | turbocharged |
02 Operational Specification
| Fuel Capacity | 36gal | 136L |
|---|
03 Transmission Specification
| Transmission Type | powershift | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 4 | |
| Max Speed - Forward | 20.6mph | 33km/h |
| Max Speed Reverse | 20.6mph | 33km/h |
04 Hydraulic Specification
| Pump Type | gear type, tandem with unloader | |
|---|---|---|
| Pump Flow Capacity | 36gal/min | 136L/min |
| Relief Valve Pressure | 3626psi | 25000kPa |
05 Backhoe Dimensions
| Load Height - Std | 11.68ft in | 3560mm |
|---|---|---|
| Reach From Swivel - Std | 18.25ft in | 5560mm |
| Dig Depth - Std | 13.92ft in | 4240mm |
| Bucket Dig Force - Std | 11982.13lb | 5435kg |
| Load At Max Lift - Std | 11389.09lb | 5166kg |
06 Dimensions Dimensions
| Transport Length | 17.26ft in | 5260mm |
|---|---|---|
| Transport Width | 12.05ft in | 3670mm |
| Transport Height | 7.62ft in | 2320mm |
07 Loader Dimensions
| Clearance At Max Dump Height | 8.67ft in | 2640mm |
|---|---|---|
| Lift Capacity At Full Height | 7200.3lb | 3266kg |
| Bucket Capacity | 1.31yd3 | 1m3 |
| Bucket Width | 92.13in | 2340mm |
| Bucket Breakout Force | _- | 45.8kN |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.